Having problems with your Air Conditioners ?

I have a Char Broil Gas grill, and ignition has become a bit of a problem lately. I can see the electric igniter sparking, I have been able to smell LPG and keep the lid open. If it does ignite, it usually does so in a fireball fashion while removing arm hair. Is this a cleaning issue, or should I just cave and buy new parts / grill.


Answers :

THis sounds like a cleanning issue, could be the grills orrifice close to the spark igniter is plugged. Wire brush please!

Repair Help & Product Troubleshooting for Air Conditioners
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

I have a Char Broil Gas grill, and ignition has become a bit of a problem lately. I can see the electric igniter sparking, I have been able to smell LPG and keep the lid open. If it does ignite, it usually does so in a fireball fashion while removing arm hair. Is this a cleaning issue, or should I just cave and buy new parts / grill.


THis sounds like a cleanning issue, could be the grills orrifice close to the spark igniter is plugged. Wire brush please! ... Air Conditioners

Lennox Conservator III G16, Furnace, Burners stay lite for 90 seconds; no blower; but exhaust fan runs continuous. If I use a jumper from the white heat wire (including white heat wire) to the green blower wire terminal (removed the green thermostat wire) the blower fan runs (non-stop) & igniter & burners restart every 10 mins. when I remove the jumper (& wire to specs from the thermostat to the furnace) igniter & burners kick on for 90 seconds then nothing on the unit works except the exhaust f


... Air Conditioners

I have a Magnasonic window-mounted air conditioner, model ACM6000. I want to remove the front grille to get to the filter, but I don't know how. I'm afraid to break the grill. There are no visible screws that hold the grille and I do not have a manual. How do I do this?


Magnasonic has customer support email [email protected] ... Air Conditioners

Went to fire up our heat this year and had no ignition. Yes, there's power to unit. It's a Ruud Model URKA-A030JK08E. I found a humming noise inside the cover and discovered a seized motor which looks to be designed for removing combustion gasses. It was not totally seized, but had a little friction when rotated by hand. I took it off, freed it up as best possible, but it will still not rotate under its own power. First question: Is this a secondary problem to the lack of ignition at the bu


... Ruud Air Conditioners

I want to remove the front grill on my Mr Slim wall unit for cleaning.


... Mitsubishi MS24WN Air Conditioner

How to remove the front grille of a panasonic air conditioner


... Panasonic CW-XC243HU Air Conditioner

I have an Armstrong COncept 1000 AC unit model #scu10e36a-2 that I need to clean the fins on - but I can't determine how to temporarily remove the grill. I want to prep it for the season and the fins and coils are filthy. Thanks for your help.


Dont worry about removing grill just make sure unit is unplugged. ... Air Conditioners

How do i remove the inside return air grill on dometic ac?


Can you send a picture of your ceiling assy? ... Dometic Air Conditioners

HOW DO I REMOVE THE FRONT GRILL FROM A GE AEW05LPG1 ROOM AIR CONDITIONER?


... GE AGP05LB Air Conditioner

I have an 8 year old 2 1/2 ton carrier compressor unit. I have already replaced the running coil and contactor. I now want to clean the coils and fan blades on the motor. I have never had reason to remove the top grill. I looks as though the fan motor is attached, and I don?t want to do anything stupid ?if I can help it? or damage or disconnect any of the wires. what is the proper way for me to access the inside of the unit so as to be able to spray off any debris that may be on the coils. So fa


Hey Bernie, it is possible to remove the 4 screws on the grill that the motor is mounted to (not the bolts holding the motor to the grill)and pull up and twist so its upside down and have someone else hold it as to not put to much stress on the wires ... Carrier 38CKC042 Air Conditioner

How to remove the front grill - Gibson Thru-Wall/Window Air Conditioner


... Gibson Thru-Wall/Window Air Conditioner

I have a Honeywell triple tower fan and I cannot figure out how to remove the grill so that we can clean the blades and inside...


Should be clipped in place, gently pry at the seams ... Honeywell Air Conditioners

Buying a used A.C. Whirlpool serial @ and bar numbers are on top nothing else removing 2 screw on front sides will release front cxover but I can;t get front grill c overing the cooling off. Milt


Hi! Just a thought, there may be one more screw inside the vent itself that holds the cover. Try checking it for mine has one screw inside that holds it. Hope this helps and have a good one! ... Whirlpool Air Conditioners

I have a magic chef ultra 97 furnace. the blower started making a noise. i removed the blower and blowed the blower out with air and lubed the back bearing with pb blaster. reinstalled blower. the blower kicks on and works fine, but the furnace won't kick on. when the furance kicks on and both the blowers start, but the pilot light dosen't try to ignite.


U may have a bad ignitor or u might not have hooked up a safety switch or u may have accidentally caused a sensor to go out not knowing but it sounds like the ignitor is bad is it a glow plug or does it spark to light ... Air Conditioners

HI HOW DO YOU REMOVE THE GRILLE COVER TO CLEAN THE CONDENSER COILS & FINS WE HAVE TWO OLD MECHANICAL 8,000 BTU HAIER UNITS TRYING TO COOL A L SHAPED ROOM OF ABOUT 850 SQ. FEET WITH TWO CEILING FANS FOR OUR MEETINGS. THANK YOU -- MR. MURPHY.


These a/c under 10,000 btu usually are brutal to get into\012Some come apart in halves others just have lots of screws\012Good Luck!\012If this was helpful please rate me.Leo Ponder Appliance-Tyler,Texas ... Haier Air Conditioners

Can you please tell me how to remove the front grill of my vulcan wall furnace to enable me to clean it . Will this give me access to the fan as well . Thanks


... Air Conditioners

I have a central heater. it will come on and worh fine, by this i mean the draft induce motor comes on, then the glow igniter will come on then flame will come on but after 10 minits or so it will stip the flame and the big blower stays running but the draft induce motor is not runing and will not come on till i turn the thermistat off then back to heat also i remove the metal cover and then it will light. please help me.


Sounds like the filter inside of the unit may be dirty and or the vent cap could be partially blocked causing the flue gas to build upo until the unit tripos on the high limit saftey ... Air Conditioners

Hi , I have a Electronic pilot lighting system on my RUUD package unit. The pilot light flame keeps blowing out or is not working properly. I removed the panel to look and see what was wrong. I could not see any faults. The sparker worked just fine, the gas line tubing was fine no blockages( took it off to inspect it) every thing looked good. Worked fine for the last couple of weeks and now it will not ignite the pilot light to light the rest of the propane gas to heat the house. I tested the fl


Sounds like you have checked most things. A pilot will go out if it is dirty, if the gas valve is not holding or if the senser is dirty or bad. Remove the pilot and clean out the small orifice inside. Check all electrical connections, clean the senso ... Ruud UBHC Air Conditioner

My A/C is extremely noisy! When I press hard on the front grill I can get it to quiet down. Remove my hand and noisy again. The owner's manual identifies it as Goldstar model BG8000ER, R1003


Mcdevito75 here, That"s a vibration from the fan, compressor, try to re-seat that front grill, it may have worked loose, or hold it tight with tape. (Duck tape) just around the edges. ... Goldstar R1003 Air Conditioner

Trying to clean a Honeywell HT-380BP High Performance Turbo Force Floor Air Circulator Fan and can not figure out how to remove the grille assembly?


... Honeywell Air Conditioners

Having unpacked a PC07-06RA from its box I noticed more polystyrene partially blocking the ventilation grill, i.e. behind it. Does this have to be removed and if so how? Having tried to operate the unit the alarm is permanently 'on'. Help! Thanks.


... Air Conditioners

I have a carrier furnace that I am working on and I do not have a schematic and the problem is I think I have a bad circuit board but I cannot prove it. the model is a 58SS080-BC The igniter will not light the pilot or even start sparking as long as the wire to the ignitor is plugged where it belongs on the gas valve as soon as you remove the wire the ignitor begins to spark.


... Carrier Air Conditioners

Boiler doesn't fire up. 25 years old Amana outdoor boiler model #3612M-A Mfg # P68191-1F,It had leak in pump housing and replaced, replaced igniter ,but no fire, no leak in system ,pump are keep running How to remove air from system and why it doesn't fire up , like to have step by step diagnosis chart Thank you.


Have a look at general maintenance tips below\015\012Boilers Inspection and Maintenance Tips ... Amana Air Conditioners

I have asked for an answer prior to this visit. I bought an Whirlpool Air Conditioner from a private party who said the unit is 2 years old. No manual available. How do I get at the filter? Removed 2 screws one on each side and I can't get the front grill or whatever to come off.


You can download the user Manuel from the link mentioned below.\015\012\015\012http://www.devicemanuals.com/guide/Air%20Condit ... Whirlpool Air Conditioners

CS-MC90KE How to remove front grill of indoor unit?


... Panasonic Air Conditioners

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || ad-trader.net || Terms of Use || Contact || Privacy Policy
Load time: 0.0438 seconds