Having problems with your Air Conditioners ?

I have a Honeywell 8124A,B,C. model aquastat. The diagram does not show zone valves connecting to this model. It only shows additional circulators. I currently have 2 zones. Can I use zone valves on the 8124A,B,C model aquastat? Do I need to purchase another control box?


Answers :

Repair Help & Product Troubleshooting for Air Conditioners
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

I have a Honeywell 8124A,B,C. model aquastat. The diagram does not show zone valves connecting to this model. It only shows additional circulators. I currently have 2 zones. Can I use zone valves on the 8124A,B,C model aquastat? Do I need to purchase another control box?


... Honeywell Air Conditioners

Panasonic Inverter CS-E12EKU timer indicator blink. The unit not work at all, I follow the manual instructions using the remote control but the instructions are not clear. Using other similar Panasonic model instruction clarify the process and get 4 seconds beep, 30 seconds power indicator on and the code F99 at the control. In the error code table for the similar model F99 means Outdoor Direct Current (DC) peak detection and instruct to verify the- Outdoor unit PCB- IPM (Power transistor) - Cop


Today I install a new unit Panasonic CS-S13KKP also have a same problem timer blink and the outdoor unit wont start. Error code is 11. after checking the problem, can not using a 3 cable cord, solve the problem using 4 Cable cord and its run ! ... Panasonic Air Conditioners

Control board I've got a Bryant Plus-90 furnace, model starts w/ 350MAV. The status code LED on the control board does not come on. Is this a problem with the control board, or is the issue somewhere else? How do I diagnose the problem? If it is the control board, what is the part number that I need? I've found part number 325878-751 that says it works for most model numbers that start with 350MAV. The word "Most" worries me. I can't find the part number on the current board.


Hello, check to see if the board is receiving 120 volts at the L1 and neutral terminals, if you are then the board will need to be replaced, if you are not getting power then trace the wirimg back to where the voltage stops, for example could be a ba ... Air Conditioners

I can not control my furnace. The handyman pulled all the control wires off trying to fix it. is there a standard way of wiring the control of a furnace. I need to hook up the Bryant Magnetic Diaphragm Valve to the thermostat, power source, hi temp safety switch and pilot. The system runs on natural gas. Valve is model ib634. Thank you for your assistance. Sincerely, Jack Cohen, Mananger Apex Property Manangement, LLC tel: 610-656-2401 e: [email protected]


... Bryant Air Conditioners

Have a teledyne laars lite LLD pool heater and was told that I needed a new ignition control unit. Replacement called for a digital ignition control unit (#RO317500) to use in replacement for model 05-339011-003 that was originally on my analog heater. Paperwork included did not give info on exactly how to wire it to the unit - there is a IND connection and a diagnostic area on the unit that was not on my original control unit. Anyone out there that knows what to do to connect it correctly? I'


... Air Conditioners

Do I only need a new condenser, or a whole new split central air conditioner system? I currently have a Bryant 340AAV with a Bryant evaporator coil model no. CD6AXW036021ABAA, outside I have a Goodman Condenser model no. CE36-1GB, My compressor has failed, HVAC said replacing compressor would not be worth it. I was about to buy a used Rheem 10 seer condenser, but I read that the minimum is 13 seer and that if the inside is a different seer from outside that would result in it breaking down. I do


Hello!The HVAC shop is likely accurate when they told you it would not be cost effective replacing a compressor alone. My advice is to contact the HVAC contractor back, and ask him what they would recommend that the condenser ... Goodman CKL42AR42 Air Conditioner

I have Carrier Comfort Zone 2 on a York system. Everything has worked fine. After recent lightning strike, the controller is not responding correctly. It flashes E1 alternating with the current temp. No matter what the programming, it seems to start cooling when the house gets to 84-85 degrees inside and then stays on continually until it hits the programmed 76-77. How do I test to see if zone panel or thermostats need replacing?


This <a\012rel='nofollow' href="www.curthel.com">carrier</a>\012\012 has everything to quickly and safely deliver\012your <a rel='nofollow' href="www.curthel.com">car</a>. ... Carrier Air Conditioners

A/C need hlep with a carrier model # 40aq030-300bb. just bought a house with this unit inside but outside different unit, think its a Goodman. When turned to heat everything ok, but when turned to cool it still puts out heat. Think reversing valve is bad or switch controlling it may be bad. Not to familiar with the system and wiring diagram is gone. Somebody made a mess of the wires anyway, need some help if you have any. Thanx and... GOD Bless


Orange or O terminal on Tstat energizes valve in colling cycle. Go to outside unit jumper red to orange and see if Reversing valve energizes. If it does . Problem inside possible Tstat. You shoulf here the valve click. Have someone inside switch fro ... Air Conditioners

Singer Down-Flo Wall Heater Series 5990 Need new off/on switch hardly used, like brand new so hate to replace the whole unit. Singer Down-Flo Wall Heater Series 5990 Model No. W-30 Catalog No. 5990 H Watts 300 Volts 240 BTU 10245 CFM 200 Control Manual


... Air Conditioners

I have installed 2 of the 3 evaporators, the other evaporator I will install at a later date. I have power at condenser and evaporator. I cannot get the evaps to come on with the remote controller? Is there a jumper or something that needs to be inplace because I am only using 2 of the 3 units? I have installed a single zone unit also and that works fine. THX


Hello,\015\012\015\012I guess the remote was 0k before you fitted the evaporators if so it may be a faulty control card, have you tried resetting the test button its inside the indoor unit near the electrical cover. ... Mitsubishi Mr. Slim MXZ30TN Air Conditioner

Need a conia airconditer remote control here in Australia. We have 2 split systems that use the same remote. Models CA 24003 & CA 3003. Conia have gone bust here and we can't get a replacement remote. Any ideas?


I had the same problem and i managed to find a universal remote control from JARCAR Electronics. Model of the remote: Digitech AR-1729. It doesn't list Conia as compatible but I managed to gain control of the aircon using the code: 291. For some reas ... Air Conditioners

Is there a second air filter inside a central ac unit ? I change my filter on the air intake faithfully. Always using high grade quility filters. it was brought to my attention that there is another filter internaly that also needs changed ! Is this correct. I have a Thermal zone model# AH24A-1T it is about 8 years old.


If you have only 1 trunkline for the return and you have a filter grille with a filter in it, it is not necessary that another filter be installed in the air handler. But if you have more than one return or if you have a fresh air intake tied into yo ... Air Conditioners

I have a rinnai gas heater ultima inbuilt (i think it is called a high efficiency 30 model) which is almost 6 years old the local plumber says the timer is faulty & a new control panel is neede however he can not locate a unit, can you please let me know where i can get one as the unit has hardly been used since installation & otherwise is in perfect condition thanks Ray


You can try www.sdsmarket.com/rinnai-parts-lists-s/750.htm. Thank you. ... Rinnai Air Conditioners

I have an older Carrier Heat Pump which I am trying to update the thermostat control with a Hunter model 44550. The problem is that the wiring to the current thermostat is as follows, G= green wire, R= red wire, W2= blue wire, O= orange wire, Y= yellow wire, E= grey wire and C= white wire. If I am reading the schematic correct for the Hunter thermostate I am to wire as follows Green to G, Red to RC, Blue to W, Orange to O, Yellow to Y/Y1, C cap it as batteries are used. It does not tell me


JUMPER STAYS BETWEEN RC AND RH SO YOU HAVE INCOMING POWER FOR BOTH COOLING AND HEATING. THE WHITE WIRE YOU SAID C IS COMMON AND SHOULD BE USED IF POSSIBLE TO COMMON TERMINAL ON NEW STAT . IF THERE IS NO COMMON, THEN CAP IT BUT YOU'LL BE CHANGING BAT ... Carrier Air Conditioners

Need care and use manual for Frigidaire electronic control airconditioner model #FAC107S1A


... Air Conditioners

I have a Carrier 4 ton unit model number 661CJ048-A which is charged with R-22 capacity is 9,25lbs. It has developed a leak at the evaporator coil. It has rust on the coils which from what I understand means the leak is there. Now currently it has only 3.25 lbs of R-22 left in it. I want to replaced the coil, but until I do I want to replace the R22 with R-134A, and be able to use the AC unit, until I can afford to puchase the coil, which I found one for $720 from a company in Florida. Do I need


First your system is 22 and 134A is a auto AC refrigerant. I have never seen it used in residential ac. I have been in AC business for 45 years. The new refrigerant is 410A or Puron. But you can not use it. Your outside unit is set up for 22. Mix 134 ... Whirlwind FH-778 Air Conditioner

My base-board hot water heat system has 3 Taco zone valves in it. One of the valves seems to be not shutting off completly when the thermostat shuts it off, and allows the zone to heat when the furnace is calling for it to heat the hot water tank (for house hot water) My question is the problem most likely in the power head of the zone valve or will I need to change the whole valve?----Thanke you--------------- Lacy Smith


No you can replace just the head no need to drain the system. Push the head in with a slight twist and it will pop off. At this point check to see if the problem has gone away. If it has replace the head, if you still have the same problem drain the ... Air Conditioners

I have a Nordyne MGHA-056ABFC-05 furnace. It currently uses a 624567 2 wire control board and 2 wire thermostat. Can I use a Nordyne 902987 relay control box (uses Nordyne 624625A control board) to connect a 4 wire thermostat to it?


You could use a $10 relay ... Air Conditioners

Model SCK7500DR needs controller


Sorry, you won't find the needed part. If it's not on amazon or ebay you won't find it. ... Sunbeam Air Conditioners

I have a Haier AC model # ESA3087. The temp control down button will not work and actually changes the fan and timer controls. Do i need a new power panel or something else.


... Haier Air Conditioners

Have a RV Dometic Duotherm 13.5K Brisk Air Conditioner, Model No: 57915.331C. Have a ducted air conditioner system. Using Dometic Quick Cool Ducted Return Air Package Model No: 3105935.039. What is the correct Control Unit to use with this system?


... Dometic Air Conditioners

I have a Burnham series 2 gas boiler with honeywell controls. The taco zone valve control calls for heat or hot water, the boiler attemps to fire but goes to retry mode. This continues until I recycle power and it fires. My plumber replaced the gas valve, no luck.


Hello. The culprit is most likely the spark electrode lead. Once the pilot lights it rectifies the current telling the pcb [printed circuit board] the pilot is on it is ok to light the main burner. Begin by replacing the electrode lead. If it is ... Air Conditioners

I have an old Kelvinator air conditioning. Not sure what the model is since I have lost the manual, but from the remote control I can see some code looking like the model number: 6711A20012M. A few weeks ago the remote control died while the air con was on. I thought this was because of the battery, so, I went on to replace the battery, and tried to turn off the air con, buttttt....it didn't work, the air con was still on no matter how many times I pressed on/off to turn it off using the remote


You're right! It's receiving sensor problem with your PCB. Only repairman who knows electronic tech could only repair. I could say the cost of repair in Indian Rupees IRS.850/- maximum. Hope it's helpful? ... Air Conditioners

With unit set to air conditioning, the controller board will not turn on the blower motor and the cooling coil freezes up. McNutt tells me the controller board is kaput and they want $550 for it. In the meantime they have jumpered over the controller so the blower runs constantly. Was hoping someone might be able to tell me where to get it for less. It is HSCI Furnace Controller For Use With All Gasses 1012-940, model HK42FZ011


? need more info like make model and serial numbers ... Air Conditioners

Good afternoon please i need a manual or any information relating to the refrigerator model number kssc48qms kitchenaid. and there is a manual that provides the knight guru but the model shown there is similar but not the same. model for mating, there is kssc48qks. where the difference in electronic and electrical parts is something simple.por example in the first model to mention the power supply is separate from the electronic control board instead on the last one mentioned the source Sparta e


Http://www.ajmadison.com/ajmadison/itemdocs/ka_import_2309068.pdf\012\012\012This is the use and care manual for that unit. ... KitchenAid Air Conditioners

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || ad-trader.net || Terms of Use || Contact || Privacy Policy
Load time: 0.2565 seconds