Having problems with your Air Conditioners ?

I have a fedders window unit ac model a6y12f2bj. Last night it was running perfectly when all of a sudden uit shut off and the LED readout, which usually just says the 2 digit tep now says

\015 I have a fedders window unit ac model a6y12f2bj. Last night it was running perfectly when all of a sudden he unit shut off and the LED readout, which usually just says the 2 digit temp now says "EE". It will no longer start, no motor, no air.. just that little red LED with its evil EE staring at me..LOL. if you have any ideas could you please send them to [email protected]\012 Thank you SO much....Hot in Tampa... Dan\015

Answers :

Repair Help & Product Troubleshooting for Air Conditioners
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

I have a fedders window unit ac model a6y12f2bj. Last night it was running perfectly when all of a sudden uit shut off and the LED readout, which usually just says the 2 digit tep now says


... Air Conditioners

Amana furnace Hello, Thanks for the sloution a few weeks ago, I am now having another problem I am getting a constant flashing LED light. the guide on the back of the panels says reversed vaccum polarity or something similar. I still have the 5 am fuse in I just saw that comment I will take it out tonight, do you think this is the issue? The symptoms are: it runs for about 30 seconds the shuts off and the LED begins flashing I hear it periodically start and repeats the above. Thanks for your hel


Sounds like the flame sensor is failing you. The sensor is located on the last burner looks like a thick piece of wire. Take some steel wool and gently clean the carbon off the surface of sensor. Should only take 5 or 6 strokes. Now if that does ... Air Conditioners

My thermostat had a blinking low battery symbol in the top left corner of the led screen and the furnce would not stay running as a result. I have changed the batteries and the furnace cut in but will only run for so long before it shuts off and the sign on the screen says heat on but the furnace is not cutting in and the temperature is way below the set temperature for the house. If I keep taking the panel off the wall and reconecting it as if i changed the batteries every time, then the furn


Your thermostat sensor is getting week. Please change your thermostat. ... Honeywell Air Conditioners

My heater is not working reliably. With the setpoint above the room temp, it may come on right away, or not for 12 hours. Pilot/igniter is ok, and will sometimes start the furnace heat going, then shuts off. New digital Honeywell thermostat, worked fine until 3 weeks ago. Thermostat says Heat when it's trying to turn on the furnace, but often nothing. Sometimes when it's starting up a loud buzzing sound comes from the furnace, perhaps a relay oscillating.


Could be an open or stuck limit switch, not really a good thing. ... Air Conditioners

Rheem Super Quiet 80 natural gas furnace shuts off as soon as the blower starts with panels on. Runs until thermostat shuts it off with top panel removed. Shuts off if you put top panel on while it is running. Made sure all registers are open and even took filters out of both return airs. No difference. Green LED is steady and so is Flame LED.


... Air Conditioners

My MSY-A17NA UNIT will start functioning normally then after about five minutes it stops blowing air and the operation led signal starts flashing. When both the operation and indicator led's are on the unit works properly. After I shut it down and start it up again the unit works fine. How can I get it to stop shutting down every 5 minutes? I'm in Hawaii and it is Hot here! Please help.


Hi,Here is a tip about Mitsubishi Air Conditioners and how to get the manuals for all of the Mitsubishi line. The manual include both troubleshooting and installation. ... Mitsubishi Air Conditioners

3 year old Beckett AFG with Clean-Cut system. New inline filter new strainer, new nozzle, flame looks correct in pattern always. Flame does not sputter prior to shut-off. I did notice that when it shut off though the motor kept running for some seconds(maybe 5 seconds)which is unlike when the motor shuts off as in a satisfied call for heat. Burner shuts down. Sometimes will run for 2 or 3 hours all normal and other times will shut down after running 15 minutes. Green led goes to "lockout" mode -


Called Beckett at 1-800-OIL-BURN and explained the problem. They told me that the solenoid on the oil pump (Clean Cut) was the cause. I purchased a new pump for $50 at the local plumbing supply and installed it. Problem solved. ... Air Conditioners

We have a newly installed Honeywell CM900 wireless programmable room thermostat and HC60NG receiver box. The temperatures seem to be working in reverse for example : Room temp 20 degrees , If we request more heat by manualy changing temp say to 25 the boiler goes off. If we reduce the temp required to say 10 the boiler comes on. Also the led light on receiver box is on when boiler is off, and off when boiler is on, this is opposite to what the instruction say should be happening.


You have wired the cooling (yellow) and the heating (white) backwards. ... Honeywell Air Conditioners

I have the toyotomi TAD-T38J portable air conditioner. It shuts off after 2 minutes after I turn it on with the remote. I have turned the timer off and it still does the same thing. I have tried turning it on with the emergency on/off switch on the front panel of the unit, and it still shuts off after 2 minutes. The screen light around the emergency on/off switch on the front flashes in blue when this happens. (Not the small led light). I have checked the water tank, and it is empty, and I have


That means you have some fairly major hardware failure inside the machine. The control board is my suspicion for sure, it definitely sounds like that is having electrical failure.. Have you called back the Toyotomi service person / people after you ... Toyotomi TADT38J Air Conditioner

Hello I have a fault coade coming up on a cassette split system Model number 40KQV130A Serial number 05AQ129878. Fault is 1 x flash amber led followed by 5 flashes of green led. Indoor fan motor shuts down. Can you help. Regards Adam Kenny


Please confirm if this is a carrier brand aircon. Refer page 53 of the attached manual.\015\012\015\012Each LED position and how many time it f ... Air Conditioners

I have a Goodman gks90703bxae gas heater. When I turn it on it runs fine heats the house the blower shuts off but then the induced draft blower stays on so the heater will not heat the next time it is supposed to I checked the flue and the drains and they are fine and it throws a code that says I need a new pressure switch but it also says that my induced blower should not be running and it is can't figure it out hope you can help thanks


Hi!!\015\012\015\012The ID Blower pressure switch may be stuck closed, and keeps the ID blower running. Replace the switch. Click on the following link for a Parts Manual for your unit to Identify the part # and order it.\015\012 ... Goodman Air Conditioners

Rheem Criterion II gas furnace, model RGLH, 8 - 10 years old. Came back from vacation and furnace won't fire up. Went through start-up procedure. Brand new digital thermostat, maybe one month old, been working perfectly, replaced batteries in in anyway to no avail. On motherboard, two green lights (LEDs) comes on, but 'flame' LED (orange) won't come on.


... Air Conditioners

After 15 seconds the fan shuts down, there is a 4 led flashes on module,also a green and orange led is flashing. I don't have the operating manual.


Check on the back of the furnace door where the control board is locate. The flashes are a code that will tell you what is wrong with the unit and on the back of the panel door that you remove should be a listing of what the flashing light is tellin ... Carrier 38CKC036 Air Conditioner

Sears Kenmore Amana window ac unit 13,000 btu: Sometimes the compressor will not shut off to cycle. Last night I woke up to an ice cold house and turned the digital temp up and the compressor wouldn't shut off so I turned the power off and the comp stayed running until I unplugged the unit. What does it sound like to you?


Sounds like a dirty coil or stuck thermostat ... Air Conditioners

My Ruud silhouette II some times will not operate. I the room temperature is below the thermostat setpoint and the status indicator on it says ''System On.'' I The unit and the green ''OK'' LED is flashing 4 times, then pausing repeatedly. After some time, the unit will function properly (I have not checked the LEDs while it is operating properly). It will work fine for weeks and then the problem reappears. Any ideas?


4 Blinks is an error code of a sticking pressure switch. A pressure switch is a safety, which in this case is being used to verify that your furnace is drafting properly. Yours in particular is sticking in the closed position even after the call for ... Ruud UAKA037 Air Conditioner

I've been using this Danby Premiere DPAC11010 for months. There are no instructions for draining it, although it came with a drain spout and rubber hose. The sticker on the front says it doesn't need to be drained - the liquid cools the compressor. The troubleshooting guide says to drain it if a certain warning light goes on. I tried draining with the hose and even rolling it out onto the deck to drain it. However, it runs for an hour or so and I get the same error and the unit shuts down again.


I see no solution do I have to be a member to view or has it not been solved? ... Danby Air Conditioners

How hard is it to install the basic honeywell thermostat non digital I believe #YCT87N1006. I just want the basic stuff no digital that keeps shutting off my furnace


Here are some instructions.\015\012http://customer.honeywell.com/techlit/pdf/69-0000s/69-0637.pdf\015\012\015\012Please rat ... Air Conditioners

I installed a Digital Thermostat to an Evaporative cooler. The pump runs for a few minutes and the Fan kicks on afterwards for 10 seconds and shuts off. What did I do wrong? Master Cooler Model MC63C 60htz Wiring from Cooler: Black, Yellow, Red, White, Digital Thermostat Black(Power), Black/Orange(Pump), White (Common) Yellow (High), Red (Low), Green(Ground)


Check to see if your Tstat has dip switches on the back they may need setting. Is your tstat programable? If so check settings. Rus ... Mastercool 67680 Evaporative Cooler Air Conditioner

Janitrol (goodman) GMS9. Two years old. When thermostat is set low the ICM diagnostic LED is continuous on ("no signal from thermostat"), when thermostat is turned up then LED gives 3 flashes. Manual says that 3 flashes means "Pressure switch circuit not closed. Induced draft blower is operating", however the ID-Blower is NOT running. I ran a 110Volt wire directly to the ID-Blower to see if it runs independent of the control and it does run. I drew vacuum on both pressure switches and they do


Bad board . replace it . ... Air Conditioners

Sanyo Condensing unit. blower fan doesnt come on unless unit runs,but unit only runs for about one minute and shuts off. led #6on cond. unit blinks and led on evap. coil #26 also blinks unit needs to be turned offon for it to restart.


First, the condensor fan is only supposed to run when the unit is on. As for the one minute run, then needing reset...this sounds like a "safety out". The air conditioner knows something is wrong and tries to protect itself. Being low on Freon wou ... Sanyo Air Conditioners

No Power Like everyone else the unit was working fine the 1st summer. Pulled it out again and nothing. It powered up for about 30 seconds then shut down. Now no power at all to the control panel. Is there a fuse link, or some kind of auto shut off I should be looking for? I can't say if it still blows hot and cold as I can't power up to find out.


Did you check the drain switch ?? this will shut them dowbn as well? ... Danby DPAC8399 Air Conditioner

I have a Goodman GMH950904CXAC. Thermostat calls for heat. It comes on and runs fine for about 5 minutes, then the circulator blower shuts off, but burners and draft blower still run. After another 15 seconds or so, the burners shut off and LED flashes 4 times. Thermostat is still calling for heat.


4 flashes is an overheat situation most likely caused by the blower not blowing. The blower relay controls the blower function. It is part of the circuit board. I suspect a new board will take care of the problem if you don't find a lose ... Goodman Air Conditioners

I have a Ducane fits all 92 my lanlord installed,about 3 months ago.The thermostat is a new digital. The temp is set on 68,and if i go to 72 for example,the furnace starts and runs fine for about 3 to 5 minutes.The burner shuts off,the blower continues to run,And the buner tries to relight,and it fails to do so.The only way to get the furnace to run again and blow hot air is to shut the system off and restart.


Sounds like you are not proving flame to me. Could be a variety of things. I think it may be the board...but that is a guess from past history with Ducane ... Air Conditioners

I have a 6 year old Carrier Performance 38yza. Having a problem with heat. First no heat at all heat pump or AUX. Found AUX heat strip were grounded out and have now been replaced. Second no heat pump, Compressor comes on for only 1 to 2 minutes then shuts down. Service call yesterday Tech says no signal from Carrier Programable T-Stat, jumper heat pump, low freon adds. Says T-stat bad, but puts back together. Heat pump works blowing 90 plus degree from vent works great all afternoon and into ni


This sounds like you have a freon leak. Most units never lose freon. So that is one problem that needs to be addressed. Here is some more solutions for you: Other things that will cause or aggravate\015\012ice are clogged filters, bad fan moto ... Air Conditioners

The outside unit does not operate. All i can hear when i turn it on is is ticks for a minute then turns off. I have reviewed the inside of the unit and no error light comes on except for a led light which is next to eh err0 led ligh, i think it says d25 or d26? please help as i can find no one who knows these systems. regards Peter Finlay


D25 code : Check power supply voltage to the outdoor unit is correct (1ph ?220 Vac ±10% or 3ph ?380 Vac ±10%). If OK, check fuses, if fuses are OK replace outdoor main PCBD26:compressor seized. Check compressor winding ... Sanyo Split System Air Conditioner

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || ad-trader.net || Terms of Use || Contact || Privacy Policy
Load time: 0.0435 seconds