Having problems with your Air Conditioners ?

I have a fedder outside unit and the unit want turn on. I checked the capacitor and the top was a little rusty and two red lights on the board where the capacitor were blinking. If it's the capacitor, what size capacitor do I need for model #CH24ACD1V?

Answers :

Repair Help & Product Troubleshooting for Air Conditioners
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

I have a fedder outside unit and the unit want turn on. I checked the capacitor and the top was a little rusty and two red lights on the board where the capacitor were blinking. If it's the capacitor, what size capacitor do I need for model #CH24ACD1V?

... Air Conditioners

After a very cold frosty night my unit stopped working. The 'operation' light was blinking a series fo 5 blinks and the 'timer' light was constantly blinking. My service man has now said both the PUMP and PRINTED CIRCUIT BOARD need replacing! OUCH! $2,500 NZD! This unit is only 6 years old. I have been told that I might get away with just replacing the PCB but it's not recomended practice. Fujitsu will not help and it is just not good enough. This unit is only used for heating so only runs for 5

Try switching off and on circuit breaker it might solve the problem ... Air Conditioners

I need the capacitor size on the Intertherm heat pump unit Model # E2EB-015HA.

... Air Conditioners

I have a Amana unit Model# PGA60C1152F that has a blinking light on the control board it blinks 4 times. That heat will come on then go off but the blower nevers comes on.

Diagnostic status codes: 1 flash, board ok.2: blown fuse-replace fuse.3:replace evaporator thermistor (Oct).4:mode switch failure-replace board.5:potentiometer failure-replace board.\0156:bad thermostatinputss chk t-stat.7:factory use only.8:re ... Amana Air Conditioners

I have a Goodman Model number AR24-1 unit and the blower moter will not start with it turned on to fan or cool or heat. I have checked the thermostat and the unit runs outside. Just no blower. Can I jump the blower motor as I replaced the capacitor today. Hear are some numbers that may help. Part Number #15212-50 Volt 208/240 Amp 1.5 HP 1/5 No heat Kit It has a Goodman switch board # B1370735 that I can check with my meter if needed. I have checked the thermostat in the attic also. Seems like

... Air Conditioners

Gas furnance would only operate for about 3-5 minutes then turn off. Replaced gas valve on furance for a Rudd comerical A/C 4 ton unit model UKKA-A048JK10E. Now the blower fan turns on but the igniator and gas does not come on as before. LED light (flashes 5 times) on board indicates flame roll out switch is open. Need manual to locate roll out switch, does it have a reset button or does it need to be replaced?

The rollout switches will be located at the ends of the burner assembly and will have a manual reset. they must be manually reset to ensure that the problem has been corrected. Most units will go into a soft lockout for a time and eventually a hard l ... Ruud UAKA042 Air Conditioner

There is a red light on the board indicate L2 is blinking i need to know what is that L2 stand for, the air condition model PU24ek-1.

L-2 stands for Open phase detective.Check power for all phases and rectify. ... Mitsubishi Mr. Slim MXZ30TN Air Conditioner

I have a Sta Rite Max E Therm pool heater and when I start the unit, the fan kicks on but the heater never does. After 45 seconds or so, I get a " Service Heater" light. The circuit board had leds for limit switch, pressure switch, air sensors, etc, but none are lit. The ignition contol module has a blinking red led which the manual says is a "ignition lockout" issue. What is an ignition lockout? Do I need to replace the HSI Ignitor? Or could it be something other than ignitor? Thanks

Hi,How many times that light is blinking?Is it 3 times sequence?Let me know,so that we could proceed.Thanks!! ... Air Conditioners

Recently purchased a second hand Carrier Split A/c -Model 42KPC019303 - 18000 BTU. The unit would work for awhile then shut off - fan included - and the green light would blink 5 times at intervals - but the unit did not start back. The sensor was changed and the unit started functioning normal for awhile - and then the problem resumed. Only difference is that this time the light blinks for about 10 mins and then the unit kicks back on. I want to know if this is a normal function, and if it ca

I have the same problem. What sensor did you change? Did you eventually solve the problem? ... Air Conditioners

I am working on a GE air conditioner Model # AZ35H15D5BMI, Serial # TA659138, manufactured date 10/01, I replace the control board part number WP26X10018 and the board fried a resistor or a diod. I have purchased a new control board and don't want to burn this board. I need a schematic of the unit to make sure I rewire the unit properly. There is no schematic in the unit that I can find, I have slide the unit out and looked in the outside unit for paper work or a diagram but have had no luck

Dear friend i got some model number for you... have a look....please click here and have a look... ... GE Air Conditioners

Amana PTAC (PTC153B35AM). Unit has simply stopped working. Power is fine from wall to capacitor and control board (but I don't know how to check other leads off of capacitor or board). There is no response from the buttons, nor does the system light even come on. There is a very slight hum when the unit is recieveing power (I think from the capacitor, but I am not completely certain). But nothing else -- resetting breaker on plug doesn't work, nor does switching off/then on the internal

Hi,\015\012\015\012The hum that you arehearing is probably the transformer so that is working...as far as what the problem is...\015\012that could be many different things...\015\012\015\012The control board just went ba ... Amana DigiSmart PTC153B35AM Thru-Wall/Window Air Conditioner

Model # m6p09s2a portable maytag air conditoner unit...red light keeps blinking at the unit where power button is located....unit will not turn on. the light just keeps blinking

Greetings,I have the same model air conditioner, and had the same symptoms. As you've probably discovered, Fedders is the company that actually built it, and went of business. No one is supporting it any more.However, you ma ... Maytag Portable Air Conditioner M6P09S2A

Older unit I have a older model split unit. model number AOU241D1 I need information on tonite. I have lost the signal from number 3 terminal the light is flashing the red 4 times, and the green light is flashing all the time. This I dont have a maunal book or a tech book, I have been talking to tech support from Fujitsu not telling me what the voltage is suppose to be. Use my wife email [email protected]

Here you have some schemes of other models, maybe the voltages are similar, but anyway you could at least see what the LED flashing means:\015\012 ... Fujitsu 18C1 Air Conditioner

Have 2 dometic duo-therm 13.5 penguin model 620015-307,front air would not start no lights electronic control unit,swapped control units with rear which was working fine,still did not work,swapped circuit boards from ac units neither unit works,returned original circuit board to rear unit now that doesn"t work either...help

Hi,It would seem as though something in the front unit is killing the circuit boards....The front circuit board was bad so the control still did not work in the front...then you swapped the circuit board from the back and killed it in the ... Dometic Air Conditioners

We have a Vulcan ducted heating unit model HX100, recently we have experienced problems with the unit where is it not heating the house, the unit goes on but blowing cold air. We have had a couple of technicians to repair it and still not working. One fixed the switch pressure & the other the flame sensor connection. We have been advised that we may need a new unit or repair the board. As we have an illness in the family, we would like to know whether we need to purchase a new unit as p

\015\012We had the same problem with our carrier heater 4 year or so ago. We had a technician and electrician try to resolve the problem. What the tech suggest was to replace the main component ... Air Conditioners

Hello , this is Bobby and I have a Coleman Mach rooftop air conditioning unit Model # 8335B8964 when I turn on the unit ,it throws the circuit breaker . I have replaced the starting capacitor and the running capacitor for the compressor, the fan runs ok.Is there a circuit board for this particular unit?

Here's a link to a service manual, with step by step tests to determine whats wrong. I'm thinking compressor shot, but this should confirm, and or help you determine for yourself. Be careful with those capacitors eh !! Read warning in service manual. ... Coleman Mach 15 Air Conditioner

Its a trane unit model# TUE060A936K3 in cooling mode condensor comes on the indoor fan does not in heating mode every thing comes on but the blower fan does not there is not a led light blinking code lable on the unit i it looks like its giving 4 blinks pause and repeat 4 blinks etc. what does this mean

Hi,\012Either the vent is blocked or the pressure switch that tells it that the purge blower is running is not working right...for some reason that switch is not making contact and so it will not let it light..\012\012heatman101 ... Air Conditioners

I have a Fedders portable air conditioner Model AEP09D2B. I have been using the heater feature at night lately. I turned it off when I got up this morning. About an hour later, it began to beep and the Warning light was blinking. I unplugged it and went to work. When I got home, I plugged it back in. The Warning light resumed blinking and the unit began to beep again.

Do you have the owner's manual for your unit to see what the warning light is trying to tell you? I looked all over to down load one from the net to see what it meant and I can't find one.It may be a simple as the filter needing cleaned a ... Fedders AEP09D2BCOM Portable Air Conditioner

Red and green blinking lights when I open the electrical panel. Unit is not cooling. What do blinking lights mean? It is Ducane model #2SH13B24P-1A

... Air Conditioners

I have a furnace 90+ . I have no power at the t-stat..no led, blank screen, and the blower will come on. The furnace is tied into a control panel. I can jumper the the unit at the furnace to have the A/C to come on. It will go thru shut down cycle and stop. 5 min. later the blower comes on.I've cut power to see if it will reset the board, no change in operation. control board has 24 volts with status light on but other lights off. All limit switches closed. I,m in need of sugestions Thanks.

Either a thermal switch is open or the pressure switch is closed at start up the system checks all of these before sending power to the T-Stat ... Air Conditioners

I have an Amcoraire model AOS091HX that also displays an F1 error code. Fuses were blown on the outside unit. I read about the fix by replacing the capacitors in the middle of the circuit board. I contacted Pridium and was told the circuit boards from China have been on order for six months, so I have nothing to lose by replacing a capacitor or two. Any other advise would be greatly appreciated.

... Air Conditioners

I have a ge model # asw12als1 12000btu room a/c.i think my thermostat is getting hung up. and wont stop running. there is a electronic board on the unit. this room a/c is just a year old. any suggestions on how to fix it? i took the front cover off. cleaned the evaporator and followed the thermostat back to board. very small space to work with. need to know if i need a new thermostat. temp in room going down to 60. even with thermostat set at 86. help please???????

... Air Conditioners

Hello. My York Diamond 80 furnace is having trouble. Last week there was a spark in the bottom near the control board. It looks fine, though. However, I have 4 blinking red lights. Installed a new blower motor, still the same 4 blinking red lights. I have checked continuity on all the limit swithces I can see. All check out okay...if I did it correctly. Can you give me other suggestions to try to get this fixed. I need heat in my house!

... Air Conditioners

I change the outdoor and indoor board on my comfort star becose to much voltage was put on it. now the lights come on but not the unit. The power light keeps blinking 15 times to be exact. and the cod

... ComfortStar 12,000 BTU Mini Split Indoor Unit - CMI12B

FUJITSU Air Conditioner Model AST24RGB-W is unable to switch on. Have checked safety switch and fuse on home circuit board and is OK. Power conected to outside unit is on and OK. Remote control has new batteries and display OK. Cleaned remote sensor panels on both remote and wall unit. ISSUE: When pressing the Start/Stop button the signal doesn't seem to be received by the wall unit. There is also no operation light on the Wall Unit. Unit does not turn on

What about the inside unit does it have power going to it. i would check the breaker for the inside unit. ... Air Conditioners

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || ad-trader.net || Terms of Use || Contact || Privacy Policy
Load time: 0.1380 seconds