Having problems with your Air Conditioners ?

I have a kelvinator kwh35hra room a/c I habe fault code e0


Answers :

Code E0 Error detail Remotecontrol transmission error (signal receiving error)
Inspected unit Remote control

Repair Help & Product Troubleshooting for Air Conditioners
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

I have a kelvinator kwh35hra room a/c I habe fault code e0


Code E0 Error detail Remotecontrol transmission error (signal receiving error)Inspected unit Remote control ... Air Conditioners

Unit in room displays fault code -0 and 6. Unit is a Sharp eco inverter AY-XP07ER. Unit runs for a few minutes and cuts out showing fault code.


Do not allow the signal receiver window to receive strong direct sunlight, since it can adversely affect its operation. If the signal receiver window is exposed to direct sunlight, close a curtain to block the light.\015\012\015\012Using ... Sharp Air Conditioners

Mitsubishi mr slim mn PUL18EK outdoor, PL18FK2 indoor. Getting Fault code P8. wires connected,correct phasing. OA thermister 4160 ohms. 77deg oa and room temp 77deg F.Large line 62.9 deg F at outdoor unit and small line 49.8 deg F. Unit drawing 6.9 amps...Why is customer getting the P8 failure code?


8 flash is a pipe temperature error. ... Mitsubishi Air Conditioners

Kelvinator fault code e6


... Electrolux Air Conditioners

Kelvinator fault code e6


... Electrolux Air Conditioners

KELVINATOR KSR20C Our split systeme air con does not heat or cool the outside fan run when on but the inside fan doesnt run the little led on the circuit board on the outside unit is blinking on for 3 sec ond off for 3 sec do these air cons have a fault codes ??


One might think so, YES! look on one of the door panels that you can remove! Thank-you-very-much! ... GE Zoneline AZ38H12DAD Split System Air Conditioner

Kelvinator split ac model ksv70hra#1 fault code e1


... Air Conditioners

Vulcan gas ducted heating systemr won't switch back on when house cools down. Fault code on heater is "4 green flashes" = "room air over temperature (auto reset)". Any ideas?


Hi,The reason the heater is cutting out is because it is getting too hot or it thinks it is too hot...Check the filter and also that enough air vents are open so it can move enough air....make sure the gas pressure is correct and that the ... Air Conditioners

Fijitsu split Model AOTR12LCC not cooling .Internal unit fan operating but not calling on the compressor to run .Room temp 35deg. Red operation light not on but green light flashes once only then two flashes constantly Do you know what fault this code indicates. John Pocock Ensign Rig32 Electrician


... Fujitsu 12R1 Air Conditioner

Kelvinator air fault codes - Air Conditioners


... Air Conditioners

New airconditioner (installed 5 days ago) not working. Turned it on for first time (after installers's demo)yesterday, left the room after it had been running about 30 min. Returned within 10 min to find it had ceased functioning, timer light flashing orange, power light no longer illuminated. Followed procedure in booklet (flashing power light indicates fault) and error code F99 came up. What can I do (I'm waiting to get intouch with after sales service.)


Do nothing on a brand new unit but let the installer or service tech fix it for free, if you go messing with it you may camoflouge the real problem and when the repair tech arrives he wont be able to observe the actual cause or fault and it will do i ... Panasonic Air Conditioners

My panasonic cs-e12hkr airconditioner will only run for approx. 20 mins then always turns off and will not turn back on no matter how hot the room gets. I have the timer turned to off, but it still turns off after a short while every time. I checked for a fault code and got F95, with 18 beeps from the unit. It seems that the timer is set to run for 20 mins and will not alter or turn off. The timer shows 8.00 as a start time and no end time, even when turned to off.


My air-con will run for about 5 mins thens switches off with timer light flashing. i have tried to retrieve the error code but it doesnt work, not sure what Im doing wrong there. I have to reset the air-con for it to switch back on again but still wi ... Panasonic CW-XC243HU Air Conditioner

Kelvinator split L3 fault code - Air Conditioners


... Air Conditioners

I ordered a universal remote control for a Kelvinator air conditioner (in Australia) and Kelvinator isnt listed on the code list - hence unable to use the remote and turn the air conditioner on. I have Googled for a Kelvinator code but am unable to find one. Can anyone assist.


... Air Conditioners

I have the error code A77 on my ariston microgenus HE 28 boiler. I have looked at the fault chart and it gives you 3 options but does not tell you how to repair or test any of them. I have empted the condense trap and pushed the reset button but the fault code is still there. any ideas????


... Air Conditioners

PANASONIC CU160C53XP FAULT CODE F33 COMES UP ON KEY PAD WHAT DOES IT MEAN HOW CAN I OBTAIN FAULT CODES FOR THIS UNIT THANK YOU FOR ANY HELP


BEST WAY IS TO GET AHOLD OF THE MFR'S TECH SUPPORT LINE EASILY OBTAINED FROM YOUR SERVICE MANUAL OR INFO (NOT SURE OF STATE) ... Fedders A6P09S2A Air Conditioner

Ecu-Maxx Marine Air-Con. Compressor Load Fault Code (CLF) appears. Air Condition turns on but then after 2 minutes, I get the CLF code. Manuarl says it is Compressor Load Fault. How do I fix this?


Clean the filter on the water pump. It may be clogged. Even if there is just a little bit of gunk in there it can cause this error. ... Air Conditioners

Vulcan eco 120 stoped working, checked fault codes and it said hot serface igntier. i changed that and tryed operation, unit still dose not light. when i press reset fault codes say failure to light, but sometims it also says slow closung gas valve. how can i fix it?


... Air Conditioners

Error code EO fault code


... Air Conditioners

Have a kelvinator split aircon model KSV 26 HRB showing error code E3. It will run and cool for about 20 seconds after the power is switched off and on but will stop showing the above error code. It is out of warranty. Can you tell me what the code means and what it needs to fix it.


... Air Conditioners

F0 Fault Code on a Shinco heat pump. What causes this fault? Is there a service manual or any technical information available to help a trade person correct this fault.


... Air Conditioners

I got a panasonic inverter a/c cs-e12eku with fault code f91and another one with code f90 what are this codes.


... Panasonic Air Conditioners

Where can I get hold of the AMCOR dual split unit (SF15) "F" fault-codes?


They are in the user manual, or on the panel by the control board. ... Air Conditioners

Fault code for Fujitsu split sytem ASTA24LCC


... Fujitsu Air Conditioners

I have vulcan ducted heated model no. 9255. The comfort control is reading the room temp as 35C when it is actually 11C, yes its freezing here. As the room temp is at its maximum reading the heating is not working. I have tried removing the batteries and restarting, the reset button and resetting the identity code, all to no avail. help! Patricia


I replaced the batteries, even though 'battery low' message was not displayed. this fixed my problem. I wish I'd have just done that to start with. ... Air Conditioners

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || ad-trader.net || Terms of Use || Contact || Privacy Policy
Load time: 0.0394 seconds