Having problems with your Air Conditioners ?

WHEN SWITCHED ON FAN CAME ON AND IGNITION FOR ABOUT 1'0 SECONDS THEN SHUT OFF AND E1 CAME ON. I AIR BLEW DUST FROM FILTER CLEANED ELECTRIC EYE WITH A CLOTH Q TIP AND BLEW IN FUEL LINE TO BE SURE IT WAS CLEAR. NOW ALL I GET UPON TURNING IT ON IS FAN AND FUEL VAPOR BUT NO IGNITION AND THE E1 LIGHT HELP TKS ED


Answers :

Make and Model number please. Gas or Oil.

Repair Help & Product Troubleshooting for Air Conditioners
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

WHEN SWITCHED ON FAN CAME ON AND IGNITION FOR ABOUT 1'0 SECONDS THEN SHUT OFF AND E1 CAME ON. I AIR BLEW DUST FROM FILTER CLEANED ELECTRIC EYE WITH A CLOTH Q TIP AND BLEW IN FUEL LINE TO BE SURE IT WAS CLEAR. NOW ALL I GET UPON TURNING IT ON IS FAN AND FUEL VAPOR BUT NO IGNITION AND THE E1 LIGHT HELP TKS ED


Make and Model number please. Gas or Oil. ... Air Conditioners

The downstairs ac unit has a pump that pumps the condensation frm the evaporator ( i assume) through a long tube outside. The AC would not kick on and the pump continuously ran. I was told to clear the line on the pump because the ac wont come on if the pump isnt working right. That was the case and I took an air compressor and blew out the line. I poured water in the pump to make sure it was working and did this three times and each time the water did pump outside. But the ac still wont come


Most older units will work regardless of what the condensate pump does. I have cleaned up enough water messes to know.\012The only way to test this is with a meter. You will need to identify the wire that turns on the AC and test it at the ther ... Air Conditioners

I get heat, but its now time fr a little A/C and the "condencer nits inside the outside fan unit are completlet covered in ice. I turned the units off and the ICE/FROST cleared out in about 1hr...I tried running it cool again and it only took 10-14min for the lines and the condencer nits to freeze up..n air came out of the vents?? had the unit 5 years with NO isssues at all...any thoughts or idea?


A system restriction can cause freeze ups. This usually either happens at one of the driers (looks like a cannister) or on a capillary tube if you unit has one. The capillary tube is a 1/8th inch line. What you can try..is tapping on cannister of ... Air Conditioners

Fan continues to run after desired heat is established , I blew out the line at pilot and the unit is taking 10 to 15 mins for fan to cut off


Looks like your fan limit switch may be bad. It fits into the warm air side of the furnace. It tells the fan to come one and off when the heat is blowing over the limit switch. Now if that limit is defective it also will affect the lighting of your h ... Carrier XHB123D X/Y Series Heat/Cool Air Conditioner

GE Zoneline HP PTAC A3B688DAALW1 WIRING DIAGRAM? Found a 6" L white wire with 1/4"F stake-ons loose from center terminal of Compressor capacitor 20/5uf going into the back wiring compartment. Not sure where it came loose from. There is a black multi stake-on terminal block up inside behind the capacitors. Attached it there to a unused spade but now fan does not run the indoor fan when in heat mode (compressor or elect. heat). Before the fan and electric heat worked but compressor just buzzed try


... GE Zoneline AZ55H07D Air Conditioner

I have a dayton fuel trimmer furnace model # 3E438A and the problem is that upon ignition to the furnace the unit runs and after about 3 minutes the units inducer fan shuts off and the flames stays on. becuz the flame stays on the flames shoot back into the unit causing the fire to burn up the wires and rollouts....why is my inducer fan cutting out?...also i notice that the contacts on the fan limit open between 5 and 6 and after this the indercer drops out while the fire stays on....its an old


It sounds to me like your draft motor is probably shuttimg off on thermal overload. They will get to hot and shut down until the motor cools down then run again.But by that time it's caused other trouble so I think you need to replace the motor first ... Air Conditioners

I HAVE NOISE AS DESCRIBED ABOVE ,I HAVE A GE ONE SPEED ,208VOLT THREE WIRE LEAD ,I BELIEVE I HAVE A FAN PROBLEM ,I HAVE A SPARE FAN FROM ANOTHER AC I REPLACED ,I NEED TO REVERSE ROTATION ON PRESENT MOTOR IN ORDER TO USE FAN ITS THE OTHER ROTATION .WILL REVERSING THE BLACK AND RED LINE LEADS DO THE JOB ,LEAVING THE BLUE TO THE CAPACITOR ,SURE WOULD THANK YOU FOR AN EMAIL ANSWER ,KIERAN NESBITT [email protected]


Hello YES red & black will change the direction,leave the blue as is. ... Bryant 463AAC008BA Air Conditioner

Hunter fans - model 28666 item 180783 when builder installed the fans, the lights blew out. Old fan was on same power line with light and it worked fine. What do you think?


... Hunter Air Conditioners

I have a unit in the attic that is installed in the attic horizontally. The condensation leaks out the unit into the overflow pan. I have had the drip pan replaced as it was cracked, the overflow line adjusted to insure positive drainage and no sags and raised the unit so it maintained positive slope towards the drain pan. I also made sure the drain line is not plugged by pouring bleach water down it and after a period of time, blew compressed air through it. What else could be the problem.


It sounds like to me that the leak is coming from inside the unit(air handler) possibly your evaporator coil is icing up and causing a build up of water just below where the 3/4" P.V.C. drain line connects. Instead of draining out the line, it is fin ... Air Conditioners

Got a Reddy Heater 55 55,000 BTU Extended Run Model-R55,B.T.U/HR. 55,000,Fuel Tank Capacity-GAL. 5.0, Date Of Approval: 7-1-1987, Approval NO. SAL-01,Pump Pressure psi 3.4, volts/hz 120 VAC/60,amps 2.0,Phase 1,Line Fusing 10amps. i clean the hole thing top to bottom and just have problems with the two screws back of the fan by the filter and need know where to adjust the fuel sprayer right by the spark plug because when clean the filter out it was pluged before and was running until i cleaned t


Hi,The only way to set the fuel pressure properly is by using a pressure gauge....Here is a tutorial on how to set ithttp://www.reddypa ... Air Conditioners

Okay I have a 14 sear two zone carrier ac since it was cool in florida the last month the system was off we turned it on earler in the week and the condenstate line was cloged no big deal i blew them both out. but one zone will not clear. even though i can run water thru the drain line to the outside no problem solid stream. when i put the float switch back in the pvc it flood and shuts down?


Sounds like a stuck float switch ... Carrier 38CKC042 Air Conditioner

1996 Coleman Niagra furnace has electric starter that clicks but does not ignite the system. Hear clicking as it trys to ignite but does not. Propane lines clear and tank is full stove works fine is right above heater box.


... Air Conditioners

I have a reddy heater r50bt kerosene heater won't pick up fuel changed roater and vein kit in back of electric moter still nothing all lines are clear and hold a vaccume and fuel filter is free flowing any one hav another possibility


... Air Conditioners

I have a dayton 1um42 standing fan. The black wire came loose from the switch and grounded out the fan. I have put a new connector on the wire but I am not sure where it connects to the switch. The switch has 9 possibilities. 7 and 9 are in use now by the orange and blue wires. Black wire?


... Air Conditioners

My oil boiler is a Danesmoor SLPJ 20-25 with an Electro Oil Inter 2011 burner. The oil tank ran out and after refilling the burner ran ok for approximately 6 minutes, the control box chattered and the boiler sound indicated flame out, with the blower continuing then re ignition, flame out, re ignition, flame out and then lockout. Considering restriction / air lock in fuel line, the tank filter was changed, pump filter was cleaned and fire valve was cleaned out which was giving a gunge restrict


The actual final solution was to replace the fuel valve/solenoid following which the boiler has run without failure.\015\012The conclusion was that the fuel valve solenoid was ok when cold but when heated up had some sort of electrical breakdow ... Air Conditioners

Heat does not come on. Furnace light blinks 3 times, indicating faulty pressure switch. I jumped the pressure switch, which caused the ignition filament to light up. However, it quickly shut off again. No gas comes out so the blower never starts up. Have checked the lines, they appear to be clear. Furnace is only about 6 years old. Any idea what is causing this and how to fix it?


Hi,When jumpering the pressure switch ...you need to let the blower start and then apply the jumper... the brain needs to see the proper sequence or it will not allow the gas valve to open...and when it shuts down the jumper must come off ... Air Conditioners

I have a Goodman heat pump model SSZ16, can I force it into a defrost cycle to make sure it defrosts correctly? It doesn't normally clear much ice when it goes into defrost. It makes a clicking noise and the conderser fan turns backwards. There is no whoosh sound, and no quick melting either.


... Air Conditioners

99 VW Passat. Heater fan does not blow- Heats some at higher speeds. Is there a temporary fix for this? I dont much care if it just works on high or not at this point. Cant find the wiring diagram for it on line to be sure I get the correct wires.


... Air Conditioners

I have a toyostove laser 56 Just got fuel and changed the fillter, there is oil in the line but it will not ignite. It chugs goes to the medium setting and then it shows ee2. What could the problem be.


If it's making the chugging or thumping sound when it starts trying to light, then you are not getting fuel to the pump. Make sure you vent the filter to get any air out. Push the float reset button on the right side of the heater on the fuel sump; y ... Air Conditioners

Not igniting, fan works, hot water working from same gas line, gas turned on to the furnace


WHY SHOULD i TELL YOU SO YOU CAN CHARGE FOR THE FREE INFO THAT YOU GET FROM ME ... Haier Air Conditioners

I have a Goodman GMP100-4 furnace. Recently, I replaced the circuit board and the thermostat, and the system worked well for about three weeks afterward. On Saturday, the furnace ceased to come on, no flame. Electronic ignition glows as it should when the call is made, but gas will not light. Gas is on for sure-I disconnected and checked the line. Can the regulator be repaired, or is it a "replacement only" part. Flame sensor does not exhibit corrosion, but I haven't disconnected it to l


I would recheck my connections to the thermostatIf they are connected and in good shape the I would suggest trying one other thing before purchasing a regulator (replacement only part). Try taking the power cord from the wall and where it connects t ... Air Conditioners

I have no heat (fan runs when called for) Diagnostic test came back clear. Ptac is just over 1 year old.


Hi; If the fan comes on and there is no heat. First I am guessing this unit has touch pad instead of the old fasion push button selector. If unit has touch pad then I would check for a clean filter first. Then this unit is equiped with safety feature ... Amana PTH123B25AJ Heat Pump Air Conditioner

Wiring compressor Replaced defective fan motor on my a/c unit. Old motor had three wires: black, yellow, brown. New generic motor has black, white, brown, brown w/white stripe. This new motor came with a new two terminal capacitor. Old cap. had three terminals. The black and white wires from motor connect across the line voltage and the other two wires connect across the capacitor. After install and trying to run the unit, found that compressor turns on for about two seconds and shuts down, but


The two terminal cap is only for the new fan motor. Connect the compressor wire back where you found it, on the 3 terminal cap. It's the terminal marked, "herm". The "common" terminal on the 3 terminal cap must still be connected to one side of the ... Carrier 38CKC036 Air Conditioner

Domestic "Quick Cool" RV air conditioner Fans blow good, air filter clean, went up top and with A air compresser and blew air threw both sides of the coiled Radiators. All clean up there. Capasitors are good and compresser. Runs good. But still no cold air. Do see one tiny line frosting up. Idea's


... Dometic Rooftop RV Air Conditioner

I ordered a new fan motor kit for Model #600315.321 the instructions are not clear on how to install the electrical, the kit came with a new capacator but no information about removing the old capacator if i add the new capacator there will be 3 capactors on the unit? do you have a wire diagram for this problem


The new capacitor is to take place of the old one feeding the motor. Other than that, it should be a simple in and out procedure. white, black, and red wires are typically hot legs and the brown wires are for the capacitor. ... Air Conditioners

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || ad-trader.net || Terms of Use || Contact || Privacy Policy
Load time: 0.1050 seconds