Having problems with your Air Conditioners ?

Error code E3 on fedders window unit. unit will only turn on for a few seconds, fan and compressor both when you hold the power button down for a few seconds but then turns off almost immediately.


Answers :

Looks like micro controller problem. Contact service center for assistance.
There are two sensors that control the pcb board.the room sensor and the coil sensor.most likley its one or both:-)

Repair Help & Product Troubleshooting for Air Conditioners
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

Error code E3 on fedders window unit. unit will only turn on for a few seconds, fan and compressor both when you hold the power button down for a few seconds but then turns off almost immediately.


Looks like micro controller problem. Contact service center for assistance. ... Fedders AED24E7F Wall/Window Air Conditioner

Have a Haier HWR05XCB air conditioner window unit that has been sitting in the garage for a few years. I cleaned it up for use in a room and plugged it in and nothing but Zeros on the digital display (00) only for about 1 second, then absolutely nothing, power button does not work. It does this every time I plug it in, I have tried several different outlets. No evidence of anything burned up or otherwise wrong from visual inspection. Is there a reset button somewhere on this unit?


... Haier Preference Plus HWR06XCA Air Conditioner

Split AC 1200-BTU Kenwood Model ANK12P Pearl series Power lights ON but Unit does not become ON. Its power LED becomes ON but buzzer does not beep as it beeps with normal power ON,and no response from remote control. When manual button is pressed for about 5 seconds, its whole two(7 segment ) LEDs become ON and then blower motor and compresser power supply relay becomes on. then the 2 (7 segment) LEDs go OFF. and timer LED becomes ON then (compressor) power LED becomes ON, then sleep LED (all on


HE, I Dont Know where youre getting these #'s from but the only thigs comes up under kenwood model ank 12p pearl series is "GERMAN" websites and nothing I could understand websites. ... Samsung AS18A6RB Air Conditioner

Amcor ALD12000EH Air Conditioner -The power light is blinking. Turned power source on and off. There is a steady green light at the plug where the reset button is. When I press the power on from the unit it comes on and goes off bet.3-5 seconds. Does this have any thing to do with the timer?


... Amcor ALD12000EH Air Conditioner

Lately my A/C unit has been turning off randomly followed by a loud beeping every few seconds for about 10 seconds along with a red light just above the power button. I'd check the manual about this issue but I've had this thing for a few years now and lost it. It's really annoying because my room generates a crapload of heat and becomes unbearable very quickly during the heat of the day.


... Haier HPRD12XC5 Air Conditioner

Remote sync I have the Model LRA074AT7... Plugged unit into wall receptacle. Label said push reset button. I did that and a second later, the power shut off; no display. Pushed the button again and it reset and shut itself off again and again. Also, I have no remote. What is the problem? What is my solution, please?


... Electrolux FRIGIDAIRE LRA074AT7 6500BTU WINDOW AIR CONDITIONER

Doesn't turn on; power indicator light is green on the plug, unit beeps when plugged in, control panel lights up for a second and goes off. tried the power button on both the panel and the remote.


... Danby DAC12070EE Air Conditioner

The unit will not start using the buttons on the unit or the remote. I removed the power for up to 12 hrs. I pushed the test and reset buttons on the circuit breaker at the wall power cord. I have power by the display panel showing error code E1 I have pushed and held down all of the buttons on the unit. Still will not start and continues to display error E1 This unit was purchased in June 2007.


Replace indoor temp sensor. ... Haier HPR09XC7 Portable Air Conditioner

Need to change A/C back to Fahrenheit. Haier HWR05XCL-L model type. all the manual says is hold power button for 5 seconds when unit is plugged in but not


... Haier HWF05XC3 5,000 BTU Air Conditioner

Ac unit front panel ( panel inside the house) got very wet from rain, and now the circuit breaker in the wall plug trips immediately when power button is pushed.


Sounds like the control box in the unit got water inside and something shorted. if you have the tools you might want to look inside it and see if any wires look burnt ... Air Conditioners

My frigidaire air conditioner cord got wet while being used and now it will not turn on. the end of the cord has "test" and "reset" buttons on the side of where it plugs in to the wall. the test button does nothing. the reset button does nothing when pressed in all the way but when slowly releasing the button the light for power will come on and blink power to the air conditioner repeatedly every second. nothing will stay on for more than 1/2 of a second and the fan will not start up at all.


Hello\015\012I would have the cord replaced.The test and reset is a ground fault,or a saftey device.\015\012If its not working correctly then have it replaced ... Frigidaire FAC124 wall/Window Air Conditioner

I have a Sharp portable room air conditioner model CV-P10NC. The power plug RESET button and TEST button will not click in order to check out the power plug as the unit will not turn on. They did test O.K. at first but the unit would still not come on. Can the power plug back be taken off to check out the fuse inside - or since it is a type of built in circuit breaker maybe it does not have a fuse inside ? The instruction manual states that " This air conditioner uses a fused power plug". The un


The fused9G.F.C.I.) cord you speak of is probably the G.F.C.I. built onto these units by design, can you or someone you know get access inside the unit and :Hot-Wire" the units cord and,bypass the power cord ( Just To Test the Unit)and see if it stay ... Air Conditioners

I have 2 Frigidaire window a/c units, model# fam18eq2a1. The landlord tells me they are brand new. Both units have the same symptoms: about 30% of the time they power on and function normally. The rest of the time nothing happens when you hit the power button. After checking the appliance plug in to make sure is plugged in, I then hit the reset button, afterwhich the digital display lights up completely, beeps, and then usually goes dead, although 1 out of 15 times it will power on and cool f


... Air Conditioners

I found the Bryant furnace 395cav048090 calling for heat but not operational. I shut off power to the unit and switched power back on and the unit started its ignition sequence. With power on the blower starts as a result of thermostat calling for heat from the unit and after a minute goes on to second phase of ignition with exhaust blower motor initiated. During this phase gas is being brought to the burner that you can smell however burner does not ignite gas. Unit continued with this opera


If you do not see a bright light before the gas releases, your ignitor is probably out. If you disconnect, you should measure ohms from the two ignitor leads. If you do not measure any, it is open and will not work. You will usually see a mark of whi ... Bryant Air Conditioners

My LG LSN182HE will not turn on using remote or the one button. I check fuses and breaker and they are fine. Power is coming into the inside unit but nothing happens when I push the power button. I turned it on AC mode and it started running. When I went back into the room later the unit was off.


You should check the condition of capacitor, there may be a small transformer inside the unit, check it for 24vac. If your problem still exists then you can contact with LG technical support at ... LG LS-K2430HL Heat Cool Mini Split Air Conditioner

I have a Haler, preference plus series, window unit, 52oo btu, HWR05XCB, lost power to unit, when power was restored now have a "E-|" message where temp usually is and the "energy saver, start and hi" buttons are lite in green. No buttons will work when pushed. what do I do?


... Haier Air Conditioners

Airconditioner has power and buttons are ligting up, the unit either just does not come on when power button is depressed (although it makes a beep) or when it does come on it rumbles without the fan operating or air coming out. Unit has been running fine for the last year.


Hello,\015\012\015\012Please provide the make and model of the aircon. Thank you. ... Air Conditioners

Panasonic Inverter CS-E12EKU timer indicator blink. The unit not work at all, I follow the manual instructions using the remote control but the instructions are not clear. Using other similar Panasonic model instruction clarify the process and get 4 seconds beep, 30 seconds power indicator on and the code F99 at the control. In the error code table for the similar model F99 means Outdoor Direct Current (DC) peak detection and instruct to verify the- Outdoor unit PCB- IPM (Power transistor) - Cop


Today I install a new unit Panasonic CS-S13KKP also have a same problem timer blink and the outdoor unit wont start. Error code is 11. after checking the problem, can not using a 3 cable cord, solve the problem using 4 Cable cord and its run ! ... Panasonic Air Conditioners

AMCOR 24,000 BTU split system. Worked fine two years, then today it had no power. Checked circuit breaker, it had popped. Reset CB and went to inside unit - would not turn on or off with remote or hard button. Checked wiring with an electrical tester, and wires to outside unit hot, as well as inside unit. No flashing codes, nothing. Unit won't turn on,even with power. Is there a fuse somewhere in the inner unit or outer unit?


I had this same problem. I disconnected the thermostat wire out side at the condenser and reconnected it and it started working. A couple days later it blew the breaker again this time I found the bus where the L1, L2. GR wire connect at the condense ... AmcorAire UCHW-H24AF2 Split System Air Conditioner

Equipment: Kohler DTV media panel Problem with the Kohler DTV II Steam Adapter Kit K1737BV Equipment: Kohler DTV media panel and digital interface.When I connect the interface to the media panel via the multi-pin cable, and power up the system, the backlit display on the interface flashes for a second and then the power button pulses. After that, the display goes faint? (I think I can see text on the display) and when I press buttons (power, USER, etc) nothing happens.If I unplug the power cor


... Air Conditioners

My fridgedaire window unit A/C and heat won't come on. I had replaced an outside light fixture a couple of weeks ago and had turned off the circuit breaker that affected this unit too. Now the unit won't come on AT ALL. I've unplugged the unit, then flipped breaker off then on again. Then plugged back in and hit "Reset" Button on the plug, then waited at least 3 min. as instructed, but still no power. The light on the plug doesn't even come on when I hit the test button. Could it be a faulty cor


Plug a light into the outlet used for the A/C, if the light does not come on when reset then the circuit breaker that provided the power to the outlet need to be reset or replaced. ... Frigidaire FAS257S2A WallWindow Air Conditioner

The unit powers up and the fan blows well. The green light above the cool icon doesn't light up. Every 45-60 seconds the unit seems to strain and the fan decreases it strength for about 3-4 seconds and then it returns to blowing as bed ore. The unit does not seem to be cooling well. The unit is about 4-5 years old with less than 100 hours of use. It gets used maybe once a year. It was recently used last week, cooled great for two days and then began to function as described. Suggestions?


... Amcor ALTL-12000E Portable Air Conditioner

The unit will not turn on after trying the pushing the power button. The green light on the reset button shows that it is on but on the display not lights are on. I tried to inplug and wait and plug the unit back in but nothing happen. This unit is a heat/cool 18,000btu window unit.


Can anyone please help me ou with my LG inverter its the jetcool green model. It wll turn on via remote thn pause then flash green on the led then turn off and shut the flap. ... LG Air Conditioners

I bought a brand new LG L1210ER Window/Wall Unit air conditioner a couple days ago. After installing the unit in the wall and properly insulating the perimeter gap around the unit I turned on the equipment. Immediately the unit starts to cool, however after 10 minutes of use it turns itself off (even the electronic display goes off) for a total of 5 seconds, yes seconds. It then turns itself on again and works fine for another 10 minutes and then shuts itself off again. This goes on for ever, in


... LG Art Cool LA091CNP Split System Air Conditioner

Cental air unit stopped working, I replaced the capacitor which had blown apart, but the unit does not restart. It works when I push in and hold the button on what I believe is the relay where the power comes into the panel of the unit. Is there another fuse or reset button that needs to be reset within the unit. Any suggestions? The model # is AC1BN036-A and it's from about 1995.


You shud test the relay with multimeter for any shorting out or restricions.\015\012locate it and test it, if it is not beeping or showing zero its defective and you gotta replace that relay if its good, well you gotta locate the shorting out i ... GE Air Conditioners

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || ad-trader.net || Terms of Use || Contact || Privacy Policy
Load time: 0.0861 seconds