Having problems with your Air Conditioners ?

Amana PTH153B35AK This unit is less than 30 days old, heats fine cools fine, but when i have it in heat mode,set @ 70 or so, as soon as the room heats up, the unit will cycle into a/c mode and blow super cold air for about 5 minutes than return to heating. Sometimes it will reach the desired temp. and turn off like it is supposed to do, but for the most part it just cycles back and forth from hot to cold...Amana has the worse help/service i have ever seen, i was on the phone for an hour,everybod

Answers :

This often happens if the unit is oversized or to close to a wall or object.

Repair Help & Product Troubleshooting for Air Conditioners
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

Amana PTH153B35AK This unit is less than 30 days old, heats fine cools fine, but when i have it in heat mode,set @ 70 or so, as soon as the room heats up, the unit will cycle into a/c mode and blow super cold air for about 5 minutes than return to heating. Sometimes it will reach the desired temp. and turn off like it is supposed to do, but for the most part it just cycles back and forth from hot to cold...Amana has the worse help/service i have ever seen, i was on the phone for an hour,everybod

This often happens if the unit is oversized or to close to a wall or object. ... Amana PTC153B35AK Air Conditioner

My Goodman furnace # GMPNO6O-4 is turning on fine but while running through it's cycle it will shut down for 3 to 5 seconds and continue with it's cycle, I have replaced all moving parts on it in the last yr and a half. The collector box and exhuast motor where lust replaced and the overheat sensor is fine but the collector box is very hot to the touch aswell. checked for cracks in the heat exchanger and checked seals to see if they where bad. I have great drainage from unit so it is not clogged

Yeah that auto cycling might be due to a contaminated flame sensor. Check out this vid dude: ... Air Conditioners

Heating problem hello! My air conditioner stopped to heat. (there is a around 8 degrees C, outside and 16 degrees inside). It worked just fine, and now, when I switched to heating mode, there was nothing. the defrost LED ond the inside unit is switched on, but air is not comming from the unit. Cooling mode works fine. If you could please help me finding the solution for my problem. Thanks in advance. RAdan GE AIR CONDITIONER SPLIT SYSTEM WON'T WORK ON HEAT CYCLE Seems to work ok doing eve

Hi Radan, Did you get this problem solved? We have an Electrolux Kelvinator Split System and ours is doing exactly the same thing. I am struggling to find a solulution. Would be great if you can offer any advice.\015\012\015\012Thanks Nic ... Air Conditioners

Installed new LG 18000 btu mini split heat pump, started it in heating mode, the unit first appears to run fine but continues to cycle in and off without reaching temp. have already changed indoor board and thermister per LG tech support request, but unit still cycles without satisfing.

A heat pump is a finely tuned machine that can be very efficient yet very frustrating at times. I could give you better advice if I were looking at the unit but hear are some things that may help. The unit has a defrost mode that cycles every 30,60,o ... Air Conditioners

Have a Bryant 340MAV condensing gas furnace. Installed a new thermostat for the A/C unit middle of summer (old one slowly died). Woke up this morning to no heat - thermostat didn't automatically kick in. Programmed it manually to kick in; fans work just fine and the unit is cycling, with thermostat reading heat. But furnace won't won't heat.

Just curious, have you changed your filter out recently? This blog talks about a problem similar to yours and the tech changed out the filter and tapped a screwdriver between the terminals of the limit switch:\015\012 ... Air Conditioners

Pilot light will not ignite to start heat cycle, a/c works unit will begin but will cut off w/out going into full heat and w/out blowing, new unit installed mid summer, heat has been working fine

Get to your funace and check inspection window on furnace. Small hole covered by glass. Check how many time the light blinks inside and that will tell you the problem. Get back to me and I will walk you thru this. Also kill power to your furnace and ... Air Conditioners

I purchased a AMCOR portable air conditioner Model ALD12000E/EH on Mar 30 2009. This unit does not heat or cool only the fan works. When the unit was first received the heater worked fine although there was a strong odor associated with the heat cycle. I am not sure if this unit is worth the cost of repair. Can you make a recommendation?

Hi path531,Do you have any further inquiry about the system? Hope it helps.Thank you for using FixYa. ... Amcor Air Conditioners

Lg lsu242he a/c runs fine but when unit is in heating cycle ,the fan wont stay on.fan came on a split second then cut off.outdoor runs fine in both heat and cool.LCD seems like it is fluttering in this mode as well.checked defrost sensors and they both are open.

Hi, whenever this type of problem is exhibited, usually we suspect the thermostat itself, as this is what ultimately controls the fan.\015\012\015\012It still maybe a sensor, (the ONLY way to tell is by substitution with a "Known Good") althou ... Air Conditioners

My coleman Mach Rv air conditioner with built in heat strip keeps tripping it's internal circuit breaker when running for any length of time. Just replaced heat strip with new one experienced same issue. I ended up with the fan continuing to run but only cold air comes out of the vents! When I removed the old unit and reset the circuit breaker it too worked again. Have no idea what is causing this to happen. The airconditing part of unit works just fine??? HELP! Ron

There should be an overload protection device in series with the low voltage wiring(t-stat wiring) Is it resting on the heat strip or too close to it? It is a saftey device to shut off the heat strips if the fan quits or a fire in the heat strip sec ... Coleman Mach III Air Conditioner

Hi the outdoor unit turns on ( fan runs) the indoor unit does open, no heat or cold air blowing. In just fan mode the unit works fine etc speed setting ok. Its a sharp split type air model # ae-a244j outdoor,ay-a244j indoor unit what would be the problem, theres only two parts in the outside unit behind the side plate where the wires info is,small black box three wires and a round unit with wires. I hope this is help full cheers andrew

My gut says that this is evidence of a bad control board(circuit board). As usual, double check that your batteries are good in the thermostat. I have seen some weird things happen when the batteries are low. This one may be a job for your local con ... Sharp Air Conditioners

Hi Expert, my reverse cycle aircon is Samsung model name=AQY09NSBN, only fan is working on the outside and inside unit at the moment, no heat air or cool air coming out of the inside unit, even tried with different temperature setting. Everything was fine till my gutter downspout was blocked and the switchbox outside near the unit was flooded and the aircon was on and off by itself every three seconds, so I turned the aircon off from the main switch outside. I got an electrician to replace the

Hi, and no your warranty is not void due to a flooded disconnect box, this is a lie!! If both fans are running, and you have no heat or cooling, the compressor is not running. This is a heat-pump with a reversing valve. The indoor unit has a control ... Air Conditioners

The outside unit is no0t able to start the fan spinning on its own. I have been able to manually engage the outside fan by turning the unit off, turning it on, and then manually spinning the fan when it starts up. The unit will then engage the fan and runs fine until the next cycle when it cannot start the fan on its own again. Can you tell me what part needs to be replaced and about how much it will cost?

Hi!!\015\012\015\012The part you need is called STARTING CAPACITOR and it is located in the same compartment where the electrical connectors are in the outside unit. MAKE SURE THE POWER BREAKER IS OFF before opening the compartment. and befor ... Air Conditioners

My father has an older model two and a half ton goodman gas package unit. it has had two boards put in it, the problem is that the unit will go through a heat cycle and the combustion motor and the circulating fans will not cut off. The loop from the board through the limits is fine. The new boards did not fix it, all components check out.

The fan induction motor produces a vacuum, check of orofice on motor is plugged by pulling hose off switch end and putting in mouth while running and sucking, this will make a whining sound immediately if no restriction. the fans are controlled throu ... Air Conditioners

Hello i have Chigo KFR51GW/GX1a 18kbtu split unit heat pump. The unit was just blowing with vertical and horrizantal air flow gowing up down L &R uncontrolable so i shut it down and restart works fine but fan stays on instead of cycling on and off as temp requires.

... Air Conditioners

Amana PTAC Unit is not producing heat. Fan works fine. can not locate manual reset for heat although a label on the unit says there is one. I have an Amana pth153b35ae ptac unit that the heat will not come on. The compressor will run in the cooling mode but not in heat mode. I verified the switching valve is working and the capacitor seems to be fine as the compressor will run in cooling mode. The thermostats seem to be functional because relays can be heard clearly when changing temperature se

I know this is late but I had to add a solution to this problem since I had the exact same problem and was able to solve it. The probelm is not your control board. On these units, the heat pump compressor will not kick in unless the temperature you ... Amana PTH123B25AJ Heat Pump Air Conditioner

Model No# AST17RSE-W My reverse cycle air con cools ok but when the unit is set to heat now it only blows cold air at a very slow speed even when when set to high speed. Last winter it was fine, summer it worked perfectly but now in winter again it's not.

Check the thermostat switch and speed sw. maybe its not functioning well. ... Air Conditioners

I am having a problem with my ac unit, the heat works fine, but when the ac is on no air comes our at all. the repair gut that cam out said that I need a new relay and sequencer,because the sequencer has a short in it, and that it would be $261 for parts and labor, if the ac is not working properly, I am concerned about paying to much and for the wrong thing,... can anybody offer advice?

If he has listed the parts on an invoice, you may try calling another repair company and ask for a price for the same job. They can probably give you a close quote over the phone. I don't know where you are but here in Oklahoma that would not be a b ... Air Conditioners

Duo therm RV a/c unit. 15,000 btu with heat pump. age-2005. Runs and starts fine.. but will shut off after 5 min. to 5 hours. no breakers trip. will restart by cycling thermostat.. sometimes.. or by unplugging thermostat and recyc;ing. any idea's??

... Air Conditioners

Dometic Duo therm RV a/c rooftop unit. 15,000 btu with heat pump. model 620515. age 5 years. Problem- will not always stay ON. Starts and cools fine. but shuts off within 5 mminutes sometimes.. or will run for hours and hours with no problems. when it stops, I can sometimes restart it by cycling thermostat.. if that does not work I can unplug thermostat from 12v power and then it starts when asked to. Have replaced computer circuit board and wall thermostat.. no change.

... Air Conditioners

My goodman heat pump has frozen up 3-4 times already this summer. It is a dual system 10 seer (i believe are the terms). Every time someone comes out they can't figure it out because the system is running fine by the time that they come. Two years ago the blower or activator was replaced (maybe the replacement part isn't so good?) The unit is 9 years old. Last year a guy charged it and about a month ago when it was checked the freon was only a little low. I'm SO tired of this issue. Any ideas

After system has been running 10-15 minutes, the discharge air temp should be 18-22 degrees colder than the air being sucked in. If the air is more than 22 degrees colder then the problem is with air flow. Check filters, blower speed, make sure all ... Air Conditioners

I have a Lg LWC122RH-2 Window Reverse Cycle Air Conditioner. It is 5 years old. The fan works fine. The Cooling and heating don't work. When I turn it on to cool setting, I can hear the compressor trying to kick in and a popping sound and can hear the unit go up and down a bit, like a humming sort of sound.

Think yu must take your compressor to the specialist so that they can check if cycling valve is operating. or may be wiring problem to the valve. ... LG Heat cool Window Air Conditioner

Works fine on cool; on heat it puts out hot air for a minute or two and then gets stuck in a defrost(I guess) cycle with a strange noise from the evaporator/fan (inside) unit. It is a Rheem branded product I think the salesman said was made by Goodman when installed about 3-4 years ago.


My GE Zoneline Air Conditioner stopped heating. The AC is just fine. I think it might be a fuse? The previous owner replaced the fuse on the Master Bedroom unit before we moved in. I can't seem to get in touch with him to find out the kind or location. Cany you help? Where is the fuse located and what is the part number?

I can not supply part numbers without knowing which fuselink or thermostat relay is nbad.To access the heater you must unplug the unit. Then remove the grill covering the top part of the evaporator. That is the cooling coil towards the front of ... GE Zoneline AZ25E12D3B Air Conditioner

This is a heating and cooling through the wall heat pump. It works normally when heating is selected - the heat pump runs and both speeds of the fan blow warm air. But nothing runs when cooling is selected. In other words the unit works normally when "High Heat" or "Low Heat" is selected but nothing runs when "High Cool", "Low Cool" or "Fan Only" is selected. The position of the Fan Cycle Switch has no effect - behavior of the unit is the same in both positions of the Fan Cycle Switch.

You have a bad board or bad switch. I would say board. You can have service tech check this out. There is only so far you can go without knowledge of Controls ad electricity. Russ ... Air Conditioners

Heat coils in central air conditioning unit look fine under examination, checked with an ohmmeter both coils showed continuity. Power at both coils indicated 110 volts. Unit fan runs fine but there is no heat at ducts. 15 amp fuse in the circuit board reads 15 amps Main 220 volt breaker for A/C unit works fine

No heat coming from my central air unit when i cut the heat on. Just cool air. what should i do. ... Air Conditioners

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || ad-trader.net || Terms of Use || Contact || Privacy Policy
Load time: 0.1058 seconds